Day 13

Ok So I started to rig my armor. And got most of it down on the chest piece. Granted I still have yet to make the spine on the back underside, and I do have some kinks to work out with the neck guard, but its progress.

I also began to toy around with some heat formed plastic and EL wire for omni tool construction. Check it out!

I hope to get to work more often now that my test is over with!  YAY

My $1 store buy :)

Here is a behind shot of what my omni tool will hope to look like. I havent actually placed the wire yet, was just putting it inbetween the plastic to get a feel for it. But I did to go back and get two more of the plastic containers from the $1 store.

Above shot

Front left.

Side clips

Here is my armor hanging on a coat hanger. It falls off if its not put on correctly.

Day 12

Hello all! I put together the back piece... mostly. I added the box, and the weapon holsters. I also added some support structure on the back with some spar parts. I also got out my webbing and some clips to start figuring out how to put this baby together. I had the webbing and straps left over from my halo costume I made with fiberglass. :) thats where the helmet was from in my last pictures.

Blue EL wire... nice

Some jimmy rigging with added support via old scraps. Cant let it go to waste now can I?

Back view

Side shot

Front and back almost done! It may look like the back is quite larger than the front, but the neck guard will be curved down a bit. and much taller than the front piece, that way I can finish the spine in the back.

Day 11

Update: 5/2/2012, fixed the pics and added captions.

Ok so don't have much time to really talk about all I've done. Plus I'm sure the pics will be a mess until I get on laptop and fix it. But almost got the back together. I raises up the pieces on the spine. Glued the neck and main back together with some jimmy rigging. And I did some detailing. More coming soon!

Ok, so here is the pieces all laid out on the ground ready to get put together.

Close up of the new box on the back. I took off 2 inches roughly and looks more proportional.

Here is the back of the neck guard as I put in the spine. Im raising it up a bit to give it a 3D feel.

Spine done!

I wasn't sure if I should raise up the circle in the middle so here is one flat.

And raised... raised = better, so I went with it.

Here is the jimmy rigging I had to do to get the pieces to stay together. Just took some scraps, glued them on and made a link so to speak.

I took some shots of what it will look like with the box and weapon holders.

Now on to some pics trying to see how it will look.

My goggles failed at protecting my eyes while using the dremel tool... fail!

So just need the back box, weapon holders and the rest of the spine!